SOLARWATT Battery & Inverter vision
Planning
Cluster Operation of the Inverter vision three/max

Cluster Operation of the Inverter vision three/max

This page describes how to set up a cluster consisting of multiple Battery vision systems and the Battery vision clusterbox. Cluster operation is only possible with devices from the same product series. A combination of Inverter vision max and Inverter vision three within a cluster is not permitted.

Inverter and Battery Combinations

Connection to the SOLARWATT Manager

Connection

Notes on Connecting to a SOLARWATT Manager:

When setting up a cluster, the SOLARWATT Manager requires data from the grid connection point via a direct connection.
The DTSU 666 duo RS485 CT 100A has two RS485 interfaces (see Figure 1 below)
When using the DTSU 666 RS485 CT 200A, a second meter is therefore required for the connection to the Manager. The Shelly pro 3EM (see Figure 2 below) is suitable for this purpose

Fig. 1 Connection between the clusterbox and the Manager via DTSU 666 duo RS485 CT 100A

Fig. 2 Connection between the clusterbox and the Manager via the DTSU 666 RS485 CT 200A and the Shelly Pro 3EM

Cluster Operation Without Backup

Separate backup outputs

Max. number of devices

A maximum of 10 Inverter vision three inverters can be connected to the clusterbox if no emergency power load is connected or if the inverters' emergency power outputs operate separately and are NOT linked.

Parallel Backup Outputs

Max. number of devices

A maximum of 4 Inverter vision three inverters can be connected to the clusterbox if the emergency power outputs of the inverters are to be connected in parallel.