Additional settings when installing additional inverters without batteries

This page describes the additional settings required on the Inverter vision if you commission it as a second inverter WITHOUT a battery when expanding an existing PV plants.

Inverter vision three

If you install the Inverter vision three as a second inverter when expanding a PV plant, you must deactivate the meter via the inverter display.
To do this, proceed as shown in the video below.

ATTENTION: As the additional inverter is not connected to a battery, you must also deactivate the battery via the settings on the inverter display Deactivate the battery via the settings on the inverter display.

Setup When Used as a Secondary Inverter Without a Battery

If you are installing the Inverter vision one as a second inverter when expanding a PV plant, you must deactivate the meter via the inverter's display.
To do this, follow the steps shown in the video below.

Print