- SOLARWATT Battery & Inverter vision
- Commissioning
- Additional settings for use as a second inverter without battery
Additional settings for use as a second inverter without battery
This page describes the additional settings required on the Inverter vision if you commission it as a second inverter WITHOUT a battery when expanding an existing PV plants.
Inverter vision three
If you install the Inverter vision three as a second inverter when expanding a PV plant, you must deactivate the meter via the inverter display.
To do this, proceed as shown in the video below.
ATTENTION: As the additional inverter is not connected to a battery, you must also deactivate the battery via the settings on the inverter display Deactivate the battery via the settings on the inverter display.

Inverter vision one
If you install the Inverter vision three as a second inverter when expanding a PV plant, you must deactivate the meter via the inverter display.
To do this, proceed as shown in the video below.

NOTE: As the supplemented inverter is not connected to a battery, the inverter display currently shows 'BMS lost fault'. This display will be corrected with an upcoming software update. The display has no influence on the correct operation of the inverter.