Panel vision XL

This page describes the type of fastening with screws, clamps or insertion system for the Panel vision XL for each mounting variant, the areas on the module frame approved for fastening and the maximum permissible pressure and suction load on the module. The definition of the clamping area (x) results from the distance between the outer edge of the module and the center of the clamp used.

Variant	Number of clamps	Number of support struts
1	4, long module side	2
2	6, long module side	3 ¹⁾
3	long module side	Insertion system
4	Mounting holes on the module	2
5	Mounting holes on the module	2
6	4, long module side	2

There must be no contact between the junction boxes and the middle support strut.
Therefore, mount the support strut with an offset to the center of the module of at least 50 to max. 100 mm.

Print